Yamaha EXo8 Betriebsanweisung

1 MTX/XMV/EXi8/EXo8 Firmware Update Guide Thank you for choosing a Yamaha product. This guide explains how to update the MTX series, XMV series, and

10 Computer TCP/IP setting ( for device main) To update device main firmware, configure computer TCP/IP settings. If only a YDIF model is being u

11 Updating the device main firmware This section explains how to update the device main firmware. Use an Ethernet cable to connect your computer t

12 About Failsafe Mode During normal operation, software must be loaded from a flash memory drive during operations to use the Dante module integr

13 10. Check the detected device. 11. Click [Start]. A pop-up is displayed confirming that you wish to proceed. 12. Click [OK] to start the reco

2 Checking the version number ・ You may check the firmware version of the device itself from the "Device Information" dialog box of MTX

3 Preparing for the update You will need the following items ready to execute the update procedure. ● A Windows computer equipped with the follow

4 Update procedure sequence Update each firmware component in the following sequence. If you're using a YDIF model, execute the shaded steps.

5 Decompressing the downloaded file Decompress the downloaded "mtx_editorxxx_firmxxx.zip" (xxx is the version number). The installer and

6 Install the Dante Firmware Update Manager (for Dante) Before you update the Dante firmware, you must install the Dante Firmware Update Manager.

7 Computer TCP/IP setting (for Dante) To update Dante firmware, configure computer TCP/IP settings. 1. Start up MTX Editor. ・The “User Account

8 Updating the Dante firmware Described below are the procedures to update the Dante module firmware integrated in the device. Use an Ethernet cabl

9 7. Check the device to update. Check the version of the update files and the version number indicated in the device line. ・If the device is not in