Yamaha BD-A1040 Handbuch PDF herunterladen (Seite 46)

44 En

Troubleshooting

■ Picture

■ Sound

Problem Possible causes and solutions

No picture. – Make sure that the cables are connected correctly. (p. 12)

– Make sure that the connected TV or the AV receiver is set to the correct input.

– With no disc inserted, or playback stopped, press and hold and on the front

panel simultaneously to set video resolution to the default value.

If a picture is still not output, press and hold on the front panel for approximately 5

seconds to switch NTSC/PAL.

– When set to Disc Native, a signal that is not compatible with the connected TV is

output. Change the setting to output a signal that is compatible with the connected TV.

(p. 37)

– Make sure that the disc or file you are trying to play back is compatible with this Player

(p. 3).

Screen freezes and operation buttons

do not work.

– Press , then restart playback.

– Turn off the power and turn on the power again.

– Press and hold p on the front panel for more than 5 seconds to reset this Player.

Video is not output with the desired

resolution.

– Set to the desired resolution. (p. 37)

Wide-screen video appears vertically

stretched, or black bands appear at the

top and bottom of the screen. Or 4:3

video appears horizontally stretched.

– Change the aspect ratio of your TV. (p. 37)

Square noise (mosaic) appears on the

screen.

– Blocks in images may be visible in scenes with rapid movement due to the

characteristics of digital image compression technology.

Problem Possible causes and solutions

No sound, or sound is distorted. – Check that the audio cable is connected correctly. (p. 12)

– Turn the volume of TV or AV receiver up.

– There is no sound during still mode, fast forward, and fast reverse. (p. 9)

– Audio may not be output depending on the audio recording status, such as when audio

other than an audio signal or non-standard audio is recorded for the audio content. (p. 3)

– Make sure that the disc or file you are trying to play back is compatible with this Player

(p. 3).

Left and right channels of audio are

reversed, or sound comes out of only

one side.

– Check the audio connection. (p. 14)

Cannot hear the desired audio type and/

or number of channels.

– Refer to Audio Output setting and “About the audio output formats”. (p. 38, p. 40)

Cannot hear the sound of PIP

(secondary audio).

– Set Coaxial / Optical or HDMI to PCM/Reencode. (p. 38)

– To hear secondary audio, press 2ND AUDIO. (p. 9)

– Depending on the disc, you may need to set secondary audio on the top menu of the

disc. (p. 9)

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 119 120

Kommentare zu diesen Handbüchern

Keine Kommentare

Yamaha BD-A1040 Handbuch Seite 46

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Blu-Ray-Player Yamaha BD-A1040