Integrated Remote Control Of The Roland Digital Snake From Select Yamaha Digital Consoles This document outlines the procedures for controlling
Now you are seeing a bank of 8 input channels. You can adjust the gain of a specific input by adjusting the corresponding trim control knob.
standard analog modules. The S-4000’s source inputs can be digitally split using standard Ethernet gigabit switches and the system’s very high qual
You can control up to 40 channels of preamp gain from the S-4000 system using the supported Yamaha consoles. SOFTWARE UPDATE FOR THE S-4000 SYSTEM
Currently there are two tested and approved RS-422 to 232c adapters which are listed here. Please check with the RSG support team at 800-380-2580
Integrity Instruments model# XP-422-9A NOTE: Always wire ONLY the connections shown; do not leave grayed-out or not-shown wires connected.
http://www.integrityusa.com/converteritemw.asp?record=50# To use this adapter you need to change the mode to DCT using the internal DIP switch. Th
Go to SYS/W CLOCK section and select the HA tab Choose the REMOTE HA tabs 1-4 Use these Knobs and Phantom Power switches to control the S-4000
When the connection is working a green “HA” will appear on the RH side of the top permanent information bar in the software when any setting is ch
Press the “EXTERNAL HA” tab (you will see the current setup of VIRTUAL RACK). You will find 4 groups of 8 input channels (when a 32x8 Roland D
Kommentare zu diesen Handbüchern