Yamaha MY16 Bedienungshandbuch

CobraNetTM Manager Lite for Yamaha Version 1.1 Owner’s Manual CobraNet Manager Lite for Yamaha Owner’s Manual EN

2. Select “Device Properties” to open the “Device properties” window. Figure 7: Device Properties Window 3. To refresh the display to show the c

Bundle Numbers Set the appropriate bundle numbers using one of the methods described below to allow transfer of audio signals between transmitting a

2. To change a connection to multicast or multi-unicast bundles, click on the vertical line that goes through the target connection point to open th

Figure 10: Matrix View Pop-up Menu 2. Select “Device Properties” to open the “Device properties” window. Figure 11: Device Properties Window 3.

Note: Don’t change the value in the Tx “Ch” field. The communication load can be reduced by changing this parameter, but some audio channels will beco

If Cannot Change Device Name and Bundle Numbers If the device name and bundle numbers cannot be changed, the IP address might not be assigned proper

2. MY16-CII Device Settings This version of the CobraNet Manager is optimized for operation with the Yamaha MY16-CII. For this reason it incorporate

2.1. MY16-CII Serial Control and Latency Settings Figure 17: Yamaha Device Settings Window Roll your cursor over the Rx or Tx field to see an edit

Click on the “Latency” field to change latency mode for audio data transferred via the CobraNet network. A popup menu will appear allowing you to sele

Figure 22: Channel per Bundle popup menu The MY16-CII handles input and output of up to 16 monaural audio channels. Up to 8 input bundles and 4 outp

Table of contents 1. Setup Guide...

2.3. Clock Synchronization Mode Like the MY16-C, the MY16-CII provides three clock synchronization modes: Network Sync, Host Sync 1, and Host Sync 2

Host Sync 2 MY16-CII Clock MY16-CII PM5D etc Figure 26: Host Sync 2 Note: In this case the MY16-CII card that is supplying the clock signal to t

Note: When Conductor Priority is set to a value other than “Auto”, the value specified via the CobraNet Manager takes priority. Note: The MY16-C cond

Special Notices ● This software is the exclusive copyright of D&R. ● Use of the software and this manual is governed by the Software Licensing A

1. Setup Guide In order to use the MY16-CII it is first necessary to set the appropriate bundle number and other CobraNet parameters. This section w

Example 2: Setting Up a Single MY16-CII card Directly connect the MY16-CII card to the computer via an Ethernet cross cable. Alternatively, connect v

Note: The “Preferences” window can be opened after the CobraNet Manager has been launched by selecting [General Preferences] from the [Setup] menu.

2. Check the “Assign IP automatically to CobraNet devices” checkbox. Note: The IP address that was assigned automatically is retained even if the p

1.3. Select an MY16-CII to be Set Up from the CobraNet Manager 1. When the “Preferences” window is closed the “Select Devices” window will open. N

1.4. MY16-CII Bundle Settings When the “Select Devices” window is closed the main window – like the one shown below – will appear. This is the Matrix