Yamaha RX-V1 Handbuch PDF herunterladen (Seite 19)

English

Hookups

RF(AC-3)

PR/CRPB/CBY

Composite VIDEO terminal

S VIDEO terminal

COMPONENT VIDEO terminals

Connecting to Digital Jacks

The RX-V1 has digital jacks for direct transmission of digital signals through either coaxial or fiber optic cables. You can use the digital

jacks to input PCM, DTS and Dolby Digital bitstreams. When you connect components to both the COAXIAL and OPTICAL jacks (for CD,

DVD, and CBL/SAT) priority is given to the input signals from the COAXIAL jack. All digital input jacks are acceptable for 96 kHz/24 bit

digital signals.

■ About the Dust Protection Cap

Pull out the cap from the optical jack before you connect the fiber optic cable. Do

not discard the cap. When you are not using the optical jack, be sure to put the cap

back in place. This cap protects the jack from dust.

About the Video Jacks

There are three types of video jacks. Video signals input through the VIDEO jacks are the conventional composite video signals. Video

signals input through the S VIDEO jacks are separated into luminance (Y) and color (C) video signals. The S-video signals achieve high

quality color reproduction.

Video signals input through the COMPONENT VIDEO jacks are separated into luminance (Y) and color difference (PB/CB, PR/CR) video

signals. The jacks are also separated into three for each signal. The description of the component video jacks may be different depending on

the component (e.g. Y, CB, CR / Y, PB, PR / Y, B-Y, R-Y/ etc.). Component video signals provide the best quality in picture reproduction.

Note:

• Each type of video jack works independently. Signals input through the composite

video, S-video, and component jacks are output through the corresponding composite

video, S-video, and component jacks respectively.

Caution:

• Use a commercially available S-video cable when connecting to the S VIDEO jacks,

and commercially available video cables when connecting to the COMPONENT

VIDEO jacks.

• When you are using the COMPONENT VIDEO jacks, check the details in the owner’s

manual that came with the component being connected.

About the RF (AC-3) Signal Input Jack

If your LD player has an RF (AC-3) signal output jack, connect it to the RF (AC-3) input jack on this unit. If RF (AC-3) and analog

signals are input at the same time, priority is given to the RF signals. When you want to reproduce RF (AC-3) signals, set the input mode

to “D.D. RF” using INPUT MODE.

Note:

• RF (AC-3) signals cannot be output using the REC OUT selector. When you record

sound or images from an LD player, be sure to connect the player to either the

DIGITAL OPTICAL or analog AUDIO jacks.

Caution:

• Even if you connect an LD player with an RF (AC-3) output jack to this unit, you

cannot reproduce Dolby Digital sound from all LD discs. You must playback an LD

disc encoded with Dolby Digital signals in order to take advantage of the Dolby Digital

sound.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 94 95

Kommentare zu diesen Handbüchern

Keine Kommentare

Yamaha RX-V1 Handbuch Seite 19

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für AV-Receiver Yamaha RX-V1