Yamaha RX-V363 Handbuch PDF herunterladen (Seite 59)

Troubleshooting

55 En

ADDITIONAL

INFORMATION

English

Refer to the table below when this unit does not function properly. If the problem you are experiencing is not listed below

or if the instruction below does not help, turn off this unit, disconnect the power cable, and contact the nearest authorized

Yamaha dealer or service center.

■ General

Troubleshooting

Problem Cause Remedy

See

page

This unit fails to turn

on or enters the

standby mode soon

after the power is

turned on.

The power cable is not connected or the

plug is not completely inserted.

Connect the power cable firmly.

—

The speaker impedance setting is

incorrect.

Set the speaker impedance to match your speakers.

The protection circuitry has been

activated.

Make sure that all speaker wire connections on this

unit and on all speakers are secure and that the wire

for each connection does not touch anything other

than its respective connection.

This unit has been exposed to a strong

external electric shock (such as lightning

or strong static electricity).

Set this unit to the standby mode, disconnect the

power cable, plug it back in after 30 seconds and then

use it normally.

—

No sound Incorrect input or output cable

connections.

Connect the cables properly. If the problem persists,

the cables may be defective.

13-17

No appropriate Audio input jack select has

been set.

Set an appropriate Audio input jack select.

No appropriate input source has been

selected.

Select an appropriate input source with

INPUT l / h on the front panel (or the input

selector buttons (

) on the remote control).

29, 30

Speaker connections are not secure. Secure the connections.

The front speakers to be used have not

been selected properly.

Select the front speakers with

SPEAKERS.

The volume is turned down. Turn up the volume.

—

The sound is muted.

Press

MUTE or

VOLUME +/– on the remote

control to resume audio output and then adjust the

volume.

Signals this unit cannot reproduce are

being input from a source component,

such as a CD-ROM.

Play a source whose signals can be reproduced by this

unit.

—

Audio signals input at the HDMI jack are

not output from any speaker terminals.

Make an analog or digital connection beside the

HDMI connection.

—

The setting of the connected component is

improper.

Make an appropriate setting following the instruction

manual of the connected component.

—

The sound suddenly

goes off.

The protection circuitry has been activated

because of a short circuit, etc.

Check that the impedance setting is correct.

Check that the speaker wires are not touching each

other and then turn this unit back on.

—

The sleep timer has turned off this unit. Turn on this unit, and play the source again.

—

The sound is muted.

Press

MUTE or

VOLUME +/– on the remote

control to resume audio output.

Sound is heard from

the speaker on one

side only.

Incorrect cable connections. Connect the cables properly. If the problem persists,

the cables may be defective.

13-17

Incorrect settings in “SP LEVEL”. Adjust the “SP LEVEL” settings.

01EN_RX-V363_U.book Page 55 Thursday, January 31, 2008 3:52 PM

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 76 77

Kommentare zu diesen Handbüchern

Keine Kommentare

Yamaha RX-V363 Handbuch Seite 59

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für AV-Receiver Yamaha RX-V363