Yamaha RX-V450 Bedienungshandbuch PDF herunterladen (Seite 23)

English

CONNECTIONS

PREPARATION

■ IMPEDANCE SELECTOR switch

Do not change the setting of the IMPEDANCE

SELECTOR switch when the unit power is switched on,

as doing so may damage the unit.

If this unit fails to turn on when STANDBY/ON is pressed

on either the front panel or remote control, the

IMPEDANCE SELECTOR switch may not be fully slid to

either position. If this is the case, slide the switch all the

way to either position when this unit is in standby mode.

Select the switch position (left or right) according to the

impedance of the speakers in your system.

CAUTION

SET BEFORE POWER ON

IMPEDANCE SELECTOR

IMPEDANCE SELECTOR switch

Switch position Speaker Impedance level

Left

Front

If you use one set (A or B), the impedance of each speaker must be

4 Ω or higher.

If you use two sets (A and B), the impedance of each speaker must be

8 Ω or higher.

The impedance of each speaker must be 6 Ω or higher.Center, Surround, Surround back

Right

Front

If you use one set (A or B), the impedance of each speaker must be

8 Ω or higher.

If you use two sets (A and B), the impedance of each speaker must be

16 Ω or higher.

The impedance of each speaker must be 8 Ω or higher.Center, Surround, Surround back

01EN_00_RXV450_EB.book Page 21 Thursday, February 5, 2004 6:17 PM

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 72 73

Keine Kommentare

Yamaha RX-V450 Bedienungshandbuch Seite 23