CONNECTIONS
Setting up the speaker parameters automatically (YPAO)
En 37
■
When an error message is
displayed during measurement
See “Error messages” (☞p. 38) for instructions on
resolving the problem and measure acoustics again.
Check the error code displayed and use YPAO to
measure acoustics again as described below.
When “E-1,” “E-2,” “E-3,” “E-4” or “E-6” is
displayed
1
Press kENTER.
2
Press kCursor E to select “EXIT.”
3
Press kENTER to terminate YPAO, and
switch the unit to standby mode.
4
Check that the speakers are properly
connected.
5
Turn on the unit and use YPAO again.
When “E-5,” “E-7,” “E-8” or “E-9” is displayed
1
Press kENTER.
2
Check that the environment is suitable for
accurate measurement.
3
Press kCursor E to select “RETRY.”
4
Press kENTER to use YPAO again.
When “E-10” is displayed
1
Press kENTER.
2
Press kCursor E to select “EXIT.”
3
Press kENTER to terminate YPAO.
4
Switch the unit to standby mode.
5
Turn on the unit and use YPAO again.
■
When a warning message is
displayed after measurement
See “Warning messages” (☞p. 39) for instructions on
resolving the problem. The speaker causing the problem
can be confirmed from the TV screen display.
To exit YPAO with some options
1
Use kCursor B / C to select “Save/Exit”
and press kENTER.
2
Use kCursor D / E to select one of the
following options and press kENTER.
SAVE:
Exits YPAO applying the results of measurement.
CANCEL:
Returns to the previous screen (warning message
screen).
EXIT:
Exits YPAO without saving the results.
kCursor B / C / D / E
kENTER
kRETURN
RETURN
ENTER
SCENE
L
ME
ENHANCE
UR. DE
DE
STRAIGHTSLEEP
URE DIRECT
OVI
USI
RADI
M
T
E
OP-U
EN
DI
PLAY
UR
E
AIN
Z
NE 2
RE
EIVE
CODE SE
NP
T
PTION
N
REE
NF
EM
RY
RESET
DMI
UDI
-
DOCK
A
NER
TUNING
k
NOTE
Although the results of acoustics measurement can be
applied when a warning message is displayed, optimal
sound will not be achieved. Resolving the problem
and using YPAO to measure acoustics again is
recommended.
Kommentare zu diesen Handbüchern