Yamaha RX-V871 Bedienungshandbuch PDF herunterladen (Seite 19)

En 19

■ Connecting speaker cables

Speaker cables have two wires. One is for connecting the

negative (-) terminal of the unit and the speaker, and the

other is for the positive (+) terminal. If the wires are colored

to prevent confusion, connect the black wire to the

negative and the other wire to the positive.

a Remove approximately 10 mm of insulation from the

ends of the speaker cable, and twist the bare wires of the

cable together firmly.

b Loosen the speaker terminal.

c Insert the bare wires of the cable into the gap on the side

(upper right or bottom left) of the terminal.

d Tighten the terminal.

Using a banana plug

(China and Australia models only)

a Tighten the speaker terminal.

b Insert a banana plug into the end of the terminal.

■ Connecting the subwoofer

Use an audio pin cable to connect the subwoofer.

Connecting front speakers that

support bi-amp connections

When using front speakers that support bi-amp

connections, connect them to the FRONT jacks and

SURROUND BACK/BI-AMP jacks.

To enable the bi-amp function, set “Power Amp Assign”

(p.89) in the “Setup” menu to “5ch BI-AMP” after

connecting the power cable to an AC wall outlet.

FRONT

+ (red)

– (black)

FRONT

Banana plug

Audio pin cable

This unit (rear)

Caution

• Before making bi-amp connections, remove any brackets or

cables that connect a woofer with a tweeter. Refer to the

instruction manual of the speakers for details. When not making

bi-amp connections, make sure that the brackets or cables are

connected before connecting the speaker cables.

• When using bi-amp connections, surround back speakers

cannot be used.

1 2

Speaker connections

3 4 5 6 7 8 9 10

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 127 128

Kommentare zu diesen Handbüchern

Keine Kommentare

Yamaha RX-V871 Bedienungshandbuch Seite 19

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für AV-Receiver Yamaha RX-V871