Yamaha R6S Wartungshandbuch PDF herunterladen (Seite 25)

SPEC

Insert it to the back end of the rib in the battery box

assembly.

The 20 mm (0.79 in) knob should be within this

range.

Pass the turn signal lead by the outside of the right

side attaching boss of the tail / brake light.

Connect the turn signal light lead couplers (two

leads).

Pass the turn signal light and license light leads

between the rear side ribs of the battery box

assembly and to the rear part of the vehicle.

Connect the license light leads (two leads).

Route the branching lead to the license light

behind the tail / brake light left side attaching boss.

Route the tail / brake light lead under the projection

part.

Route the tail / brake light lead above the projection

part.

There should be no remarkable difference

between the tension on right and left bands.

Point the tool kit opening to the rear side of the

vehicle.

Connect the tail / brake light lead coupler.

Make sure that the hooks (four positions) of the

battery box assembly catch the upper surface.

(They should not run on the side face.)

When assembling ECU, make sure that the pawls

of the battery box assembly catch.

Route the fuse box lead under the ECU connection

coupler.

Install the wrapping clamp of the wire harness to

the hole of the battery box assembly.

CABLE ROUTING

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 63 64

Keine Kommentare

Yamaha R6S Wartungshandbuch Seite 25