Yamaha mLAN Patchbay Bedienungshandbuch PDF herunterladen (Seite 5)

1. Connect the computer and mLAN devices using the IEEE1394 cables.

2. Start mLAN Graphic Patchbay (page 6).

3. Set up wordclock on the mLAN network (page 25).

4. Conﬁgure the routing of audio and MIDI signals on the mLAN network (page 25).

5. Specify the audio and MIDI inputs and outputs as per the owner’s manual for your

DAW (Digital Audio Workstation), audio sequencer, and/or connected devices.

For subsequent steps, refer to the owner’s manual for the software and connected devices.

■ Page reference

•To change the sampling frequency (Sample Rate)..........................................................See page 20.

•To set the number of audio channels for mLAN transmission

.........................................................................................See page 20 and 22.

•To change the nickname for the mLAN devices (nodes) or connectors .......................See page 22.

•To set the mLAN Driver Setup parameters.....................................................................See page 21.

•To change the latency ..................................... See the section regarding changing settings after

installation in the Installation Guide.

•If the computer and mLAN devices are unable to communicate .................................See page 41.

Operational Flow

■ If multiple IEEE1394 interface cards have been installed on the computer:

mLAN Graphic Patchbay cannot simultaneously operate mLAN devices connected to multiple

IEEE1394 interface cards. Before you start mLAN Graphic Patchbay, select in the mLAN Driver Setup

window the IEEE1394 interface card you wish to use (page 21).

1 2 3 4 5 6 7 8 9 10 ... 42 43

Keine Kommentare

Yamaha mLAN Patchbay Bedienungshandbuch Seite 5