Yamaha EXo8 Bedienungshandbuch PDF herunterladen (Seite 11)

Setup

EXi8/EXo8 Owner’s Manual

5. Plug the Euroblock plug into the [INPUT] con-

nector of the EXi8 or the [OUTPUT] connector

of the EXo8.

Here’s how to initialize the EXi8/EXo8’s internal memory,

restoring it to the factory settings.

1. Power-off the EXi8/EXo8.

2. Set the rear panel DIP switches 7 and 8 to the

“INITIALIZE” position.

3. Power-on the EXi8/EXo8.

Initialization will start.

The status of execution is shown by the [ALERT], [NET-

WORK], and [YDIF] indicators on the front panel.

• During initialization:

The [NETWORK] indicator and the [YDIF] indicator

will flash rapidly.

• Initialization completed:

The [NETWORK] indicator and the [YDIF] indicator

will flash slowly.

• Initialization failed:

The [ALERT] indicator will flash.

4. When initialization is completed, power-off the

EXi8/EXo8 once again.

5. Set the rear panel DIP switches 7 and 8 to the

“RESUME” position.

6. Power-on the EXi8/EXo8 again.

The EXi8/EXo8 will start up in its factory-set state.

NOTE

When connecting unbalanced cables to the [INPUT] con-

nector, use a jumper wire to connect the “-” and “G” of the

Euroblock.

–

Initializing the EXi8/EXo8

CAUTION

Do not turn off the power to the EXi8/EXo8 during ini-

tialization. Otherwise, a malfunction may occur

NOTE

If initialization failed, contact Yamaha representatives /

authorized distributors to have the device inspected. A list of

Yamaha representatives / authorized distributors appears

near the end of this manual.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Keine Kommentare

Yamaha EXo8 Bedienungshandbuch Seite 11