OWNER’S MANUALIntegrated AmplifierAB
CONTROLS AND FUNCTIONS8 En Installing batteries Operation rangePoint the remote control at the remote control sensor on this unit and remain within
9 EnMake sure to connect L (left) to L, R (right) to R, “+” to “+” and “–” to “–”. If the connections are faulty, no sound will be heard from the spea
10 EnCONNECTIONS REC jacks• The audio signals are not output via the LINE 2 REC or LINE 3 REC output jacks when LINE 2 or LINE 3 is selected with the
11 En1 Rotate the VOLUME control on the front panel fully counter-clockwise so as not to play sounds loud suddenly.2 Press A (power) switch on the fro
12 EnPLAYBACK Making it easier to hear the high- and low-frequency ranges even at low volume (LOUDNESS)Enjoy natural sound even at low volume by lowe
13 EnRefer to the chart below if this unit does not function properly. If the problem you are experiencing is not listed below or if the instructions
14 EnTROUBLESHOOTINGNo sound. Playback has been stopped on the connected component.Turn the component on and start playback.11No appropriate input sou
15 EnAUDIO SECTIONSPECIFICATIONSItem A-S701 A-S501 A-S301Minimum RMS output power8 Ω, 20 Hz to 20 kHz, 0.019% THD 100 W + 100 W 85 W + 85 W 60 W + 60
16 EnSPECIFICATIONSGENERALSpecifications are subject to change without notice.Signal to noise ratio (IHF-A network)PHONO (MM) (5 mV input shorted)82 d
17 EnSPECIFICATIONSInformation for Users on Collection and Disposal of Old Equipment and Used BatteriesThese symbols on the products, packaging, and/o
CAUTION: READ THIS BEFORE OPERATING YOUR UNIT.i En1 To assure the finest performance, please read this manual carefully. Keep it in a safe place for f
Printed in Malaysia ZM52710-1
1 EnUSEFUL FEATURES ... 1SUPPLIED ACCESSORIES... 1CONTROLS AND FUNCTIONS... 2Front
2 En1 A (power) switchTurns on and off the power of this unit.Even when this unit is turned off, this unit consumes a small amount of power.2 Power in
CONTROLS AND FUNCTIONS3 En8 BALANCE controlAdjusts the sound output balance of the left and right speakers to compensate for sound imbalances.If you r
CONTROLS AND FUNCTIONS4 En1 CD input jacksUsed to connect a CD player (see page 9).2 PHONO jacks and GND terminalUsed to connect a turntable that uses
CONTROLS AND FUNCTIONS5 En0 VOLTAGE SELECTOR (General model only)Used to set to your local main voltage (see page 10).A IMPEDANCE SELECTOR switchDo no
CONTROLS AND FUNCTIONS6 En1 Infrared signal transmitterSends infrared signals.2 A AMPTurns this unit on, or sets it to standby mode.3 OPEN/CLOSEOpens
CONTROLS AND FUNCTIONS7 En7 VOLUME +/–Increases or decreases the sound output level.8 MUTEReduces the current volume level by approximately 20 dB. Pre
Kommentare zu diesen Handbüchern