Yamaha HTR-5590 Handbuch PDF herunterladen (Seite 63)

English

INTRODUCTION

PREPARATION

BASIC OPERA-

TION

ADVANCED

OPERATION

ADDITIONAL

INFORMATION

APPENDIX

SET MENU

Normal -10dB

1F MAIN LEVEL

Normal -10dB

1F MAIN LEVEL

2 LOW FRQ TEST

Use this feature to adjust the output level of the

subwoofer so it matches that of the other speakers in your

configuration. Change the setting with the remote control

while sitting in the listening position.

1 Press j / i to set “TEST TONE” to ON, and

adjust the volume with VOL +/– so you can

hear the tone.

Notes

• Do not turn up the volume too high.

• If no test tone is heard, turn down the volume, set this unit in

the standby mode and make sure all the necessary connections

are correct.

2 Press d to go to “OUTPUT” and press j / i

to select the speaker you want to compare

with the subwoofer.

If SWFR is selected, the test tone above 90 Hz will

not be output from the subwoofer. The test tone will

not necessarily be output from the selected speakers.

The output mode of the test tone depends on the

settings of “1 SPEAKER SET” on the SET MENU.

■ 1F MAIN LEVEL (main level

mode)

Change this setting if you cannot match the output level

of the center, rear (L/R) and rear center speakers with the

main speakers because of the unusually high-efficiency

performance of the main speakers.

Choices: Normal, –10 dB

Initial setting: Normal

Normal

Select this if you can match the output level of your effect

speakers with that of your main speakers when using the

test tone.

–10 dB

Select this if you cannot match the output level of your

effect speakers with that of your main speakers when

using the test tone.

2 LOW FRQ TEST

OUTPUT…MAIN L/R

FRQ……………………88Hz

≥ TEST TONE…………ON

2 LOW FRQ TEST

≥ OUTPUT…MAIN L/R

FRQ……………………88Hz

TEST TONE………OFF

■ 1G SP B SET (speaker B set)

Use this feature to select the location of the main speakers

to be connected to the SPEAKERS B terminals.

Choices: MAIN, ZONE B

Initial setting: MAIN

MAIN

Select this to turn on/off SPEAKERS A and B when the

speakers connected to the SPEAKERS B terminals are set

in the main room.

1G SP B SET

-/+ : Select

/ : Exit

“MAIN ZONE B

ZONE B

Select this if the speakers connected to the SPEAKERS B

terminals are set in the second room. If SPEAKERS A is

turned OFF and SPEAKERS B is turned ON, all the

effect speakers in the main room are muted and the sound

is output only from SPEAKERS B. When a DSP program

is selected, this unit automatically enters the Virtual

CINEMA DSP mode. If the headphones are connected to

PHONES jack on this unit in the Virtual CINEMA DSP

mode, this unit enters the SILENT CINEMA DSP mode

and the sound is output from both headphones and

SPEAKERS B.

1G SP B SET

-/+ : Select

/ : Exit

MAIN “ZONE B

0109HTR5590_55-67_EN(U) 02.8.5, 4:31 PM59

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 87 88

Kommentare zu diesen Handbüchern

Keine Kommentare

Yamaha HTR-5590 Handbuch Seite 63

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für AV-Receiver Yamaha HTR-5590