Yamaha RX-V493 Bedienungshandbuch PDF herunterladen (Seite 20)

EXCHANGING PRESET STATIONS

You can exchange the places of two preset stations with each

other as shown below.

Example)

If you want to shift the preset station on E1 to A5, and vice

versa.

STANDBY/ON

NATURAL SOUND STEREO RECEIVER

SPEAKERSPHONES

OFF

BASS TREBLE BALANCE

VOLUME

–dB

MAN’L

AUTO FM

TUNING

MODE

AUTO

MAN’L MONO

DOWN

TUNING

MEMORY

EDIT

2 3 4 5 6 7 8

TUNER

PHONO

AUX

TAPE 1/MD

TAPE 2

MONITOR

LOUDNESS

FLAT

–

30dB

2, 4

1 Recall the preset station on E1 (by following the method

of “To recall a preset station” on page 18).

3 Recall the preset station on A5 by following the same

method as in step 1.

Flashes.

EDIT

MEMO

When the automatic preset tuning is finished;

The display shows the frequency of the last preset station.

Check the contents and the number of preset stations by

following the procedure of the section “To recall a preset

station” on page 18.

To recall a preset station

Simply follow the procedure of the section “To recall a preset

station” on page 18.

A recalled station is shown by the frequency or station name

on the display.

A recalled station is shown by the frequency on the display.

Notes

●

You can replace a preset station by another FM or AM

station manually by simply following the procedure of the

section “To store stations” on page 18.

●

The automatic preset tuning search will be performed

through all RDS network frequencies until stations are stored

up to E8. If the number of received stations is not enough to

be stored up to E8, the search is finished automatically after

searching all frequencies.

●

With this function, only RDS stations with sufficient signal

strength are stored automatically. If the station you want to

program is weak in signal strength, tune to it in monaural

manually and program it by following the procedure of the

section “To store stations” on page 18.

* There may be a case that this function cannot receive a

station which could be received by the automatic tuning

method. This is because this function receives a large

volume of PI (Program Identification) data along with the

station.

●

If the number of received stations is not enough to be stored

up to E8, the search is finished automatically after searching

all frequencies.

●

With this function, only FM stations with sufficient signal

strength are stored automatically. If the station you want to

program is weak in signal strength, tune to it in monaural

manually and program it by following the procedure of the

section “To store stations” on page 18.

RX-496RDS, RX-396RDS

RX-496, RX-396

RX-496 and RX-396 only

RX-496RDS and RX-396RDS only

Shows the exchange of

stations is completed.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 135 136

Kommentare zu diesen Handbüchern

Keine Kommentare

Yamaha RX-V493 Bedienungshandbuch Seite 20

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Empfänger Yamaha RX-V493