Yamaha F6 Bedienungshandbuch PDF herunterladen (Seite 32)

Installation

5. Mount the outboard motor on the center

line (keel line) of the boat, and ensure

that the boat itself is well balanced. Oth-

erwise the boat will be hard to steer. For

boats without a keel or which are asym-

metrical, consult your dealer.

6. Turn the steering friction adjuster coun-

terclockwise to set the steering friction

according to operator preference.

WARNING! If there is too much resis-

tance it could be difficult to steer,

which could result in an accident.

[EWM00721]

EMU39740

Mounting height

To run your boat at optimum efficiency, the

water resistance (drag) of the boat and out-

board motor must be made as little as possi-

ble. The mounting height of the outboard

motor greatly affects the water resistance. If

the mounting height is too high, cavitation

tends to occur, thus reducing the propulsion;

and if the propeller tips cut the air, the engine

speed will rise abnormally and cause the en-

gine to overheat. If the mounting height is too

low, the water resistance will increase and

thereby reduce engine efficiency. Mount the

outboard motor so that the anti-cavitation

plate is between the bottom of the boat and a

level 25 mm (1 in) below it.

1. Center line (keel line)

ZMU06835

ZMU01760

1. Steering friction adjuster

1. Idle hole

2. Anti-cavitation plate

ZMU06834

ZMU06796

0-25 mm

(0-1 in)

U6BV10E0.book Page 27 Friday, July 17, 2009 2:29 PM

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 79 80

Keine Kommentare

Yamaha F6 Bedienungshandbuch Seite 32