Yamaha MDX-596 Bedienungshandbuch PDF herunterladen (Seite 2)

E-2

CAUTION: READ THIS BEFORE OPERATING YOUR UNIT.

1. This unit is a sophisticated mini disc recorder. To ensure

proper operation for the best possible performance, please

read this manual carefully.

2. Install your unit in a cool, dry, clean place with good

ventilation. Avoid placing it in direct sunlight, near

sources of heat, or in locations subject to vibration,

excessive dust, heat, cold, or moisture. To avoid humming

sounds, position the unit away from other electrical

appliances, motors, and transformers.

3. Do not operate the unit upside-down. It may overheat,

possibly causing damage.

4. Do not place another component on top of this unit, to do

so may discolor or damage the surface of the unit.

5. Do not open the cabinet of this unit, to do so may result in

damage to the unit or electrical shock. If any foreign object

or substance gets into the unit, contact your dealer for

assistance.

6. When removing the power plug from the wall outlet,

always pull directly on the plug; never pull the cord itself.

7. Do not apply excessive force when operating switches and

knobs.

8. When moving the unit, be sure to first disconnect the

power cord from the AC outlet and disconnect all cords

connecting the unit to other equipment.

9. To prevent damage by lightning, disconnect the power

cord from the wall outlet during an electrical storm.

10. Do not attempt to clean this unit with chemical solvents as

this may damage the finish. Use a clean, dry cloth.

11. Be sure to read the “TROUBLESHOOTING” section for

advice on common operating errors before concluding that

your unit is faulty.

12. Keep this manual in a safe place for future reference.

13. The voltage to be used must be the same as that specified

on this unit. Using this unit with a higher voltage than that

which is specified is dangerous and may result in a fire or

other type of accident causing damage. YAMAHA will not

be held responsible for any damage resulting from use of

this unit with a voltage other than that which is specified.

Note

Please check the copyright laws in your country to record

from records, compact discs, radio, etc. Recording of

This mini disc recorder is

classified as a CLASS 1

LASER product.

The CLASS 1 LASER

PRODUCT label is located

on the rear exterior.

(U.K., Europe and general

models only)

For U.K. customers

If the socket outlets in the home are not suitable for the

plug supplied with this appliance, it should be cut off

and an appropriate 3 pin plug fitted. For details, refer to

the instructions described below.

Note: The plug severed from the mains lead must be

destroyed, as a plug with bared flexible cord is

hazardous if engaged in a live socket outlet.

IMPORTANT

THE WIRES IN MAINS LEAD ARE COLOURED

IN ACCORDANCE WITH THE FOLLOWING

CODE:

Blue: NEUTRAL

Brown: LIVE

As the colours of the wires in the mains lead of this

apparatus may not correspond with the coloured

markings identifying the terminals in your plug,

proceed as follows: The wire which is coloured

BLUE must be connected to the terminal which is

marked with the letter N or coloured BLACK. The

wire which is coloured BROWN must be connected

to the terminal which is marked with the letter L or

coloured RED.

Making sure that neither core is connected to the

earth terminal of the three pin plug.

CAUTION FOR CARRYING THE UNIT

Before carrying the unit, first remove a disc from the unit,

press POWER to turn the unit off, then disconnect the AC

power plug from the wall outlet.

WARNING

To reduce the risk of fire or electric shock, do not expose this

appliance to rain or moisture.

To avoid electrical shock, do not open the cabinet.

Refer servicing to qualified personnel only.

DANGER

Invisible laser radiation when open and interlock failed or

defeated. Avoid direct exposure to beam.

CAUTION

Use of controls or adjustments or performance of

procedures other than those specified herein may result in

hazardous radiation exposure.

Voltage Selector <General model only>

The voltage selector on the rear panel of this unit must

be set for your local main voltage BEFORE plugging

into the AC power supply.

Voltages are 110/120/220/240 V AC, 50/60 Hz.

CLASS 1 LASER PRODUCT

LASER KLASSE 1 PRODUKT

LUOKAN 1 LASERLAITE

KLASS 1 LASER APPARAT

1 2 3 4 5 6 7 ... 183 184

Kommentare zu diesen Handbüchern

Keine Kommentare

Yamaha MDX-596 Bedienungshandbuch Seite 2

Kommentare zu diesen Handbüchern