Yamaha CS2x Anleitung zur Fehlerbehebung PDF herunterladen (Seite 69)

Bank and Program Changes with LOGIC

In the CS2x Performance Mode, you can set sounds for Multi Parts 5 - 16 as well as for the actual Perfor-

mance Layers (1 - 4).

If you are working with the EMAGIC LOGIC sequencer program you can try this out like this:

1. Load Song Setup “SetIni” in LOGIC Format from the SETUP Disk’s “Setups” folder

This Setup contains pre-programmed Bank and Program changes for Parts 5 - 16.

2. Viewing the Setup File

Highlight track 5’s Setup Part and open the Event List with WINDOW - OPEN EVENT LIST. All setup data for

MIDI channel 5 will be shown. The first three events comprise the BANK and PROGRAM CHANGES and

look like this:

Position

Status CHA NUM VAL Length/Info

1 2 1 3 Control 5 0 0 Bank MSB

1 2 1 13 Control 5 32 0 Bank LSB

1 2 1 23 Program 0 0

Controller 0 is set to (MSB) value 0 in the first line.

Controller 32 is set to (LSB) value 0 in the second.

Finally, Program 1 is selected with value 0 (conversion always required).

3. Changing the Bank and Program Selection

You can use the above scheme for your own songs. Use EDIT - COPY / PASTE to copy the Setup Part to

other arrangements.

You then only need to change two values for Bank changes:

The first line always consists of MSB value 63 for “Material Voices” for VAL. You can leave it at MSB 0 for XG

voices. In the second line, VAL is always the LSB value required for the desired bank change. You can look

these up in the DATA LIST, pages 6 - 8 (XG Voices) and 11 - 14 (Material Voices).

Example: You wish to select Program 25 “ObeStrgA” from Bank Pre08.

The heading of the table (Data List, page 11) s

”

hows the MSB value is 63 and the LSB value is 8. These are

inserted into the Event List in the VAL columns of the first (MSB) and the second (LSB) lines. Insert Pro-

gram 25 for the third line’s NUM.

4. Setting up Drumkits

Drumkits are normally assigned to MIDI channel 10. The Setup File presets this to the “Standard Kit” (XG). If

you wish to use a particular CS2x drumkit instead (DATA LIST, pages 15 - 17) you will need to change the

first line’s MSB value to 63 and the second line’s LSB value to 12 (each in the VAL column). You can then

use Programs 1 to 22 in the third line to select the drumkit you want.

These Bank and Program changes only come into effect when all three events are played back in sequence,

or when they are click-selected in the EDIT mode. The CS2x must not be in EDIT mode during playback, as

it ignores all controller messages in this mode. If things don’t work as expected, ensure that the CS2x Parts

correspond to the MIDI reception channels (UTILITY - RCV-CH + PART/LAYER button).

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 75 76 77

Keine Kommentare

Yamaha CS2x Anleitung zur Fehlerbehebung Seite 69