Yamaha PSR330 Bedienungshandbuch PDF herunterladen (Seite 72)

■ Local Control

“Local Control” refers to the fact that, normally, the PSR-330 keyboard controls the

internal tone generator, allowing the internal voices to be played directly from the

keyboard. This situation is “Local Control on” since the internal tone generator is

controlled locally by its own keyboard. Local control can be turned off, however, so

that the keyboard does not play the internal voices, but the appropriate MIDI

information is still transmitted via the MIDI OUT connector when notes are played on

the keyboard. At the same time, the internal tone generator can respond to MIDI

information received on channels set to the “nor” (normal) mode via the MIDI IN

connector. This means that while an external MIDI sequencer, for example, plays the

PSR-330 internal voices, an external tone generator can be played from the PSR-330

keyboard. The default Local Control setting is “on”.

MIDI Functions

■ Clock

Reception of an external MIDI clock signal can be enabled or disabled as required.

When disabled (“off”), all of the time-based functions (Auto Accompaniment, SONG

recording and playback, etc.) are controlled by its own internal clock. When MIDI

clock reception is enabled (“on”), however, all timing is controlled by an external

MIDI clock signal received via the MIDI IN terminal (in this case the PSR-330

TEMPO setting has no effect). The default setting is “off”.

Local

oFF

ExtClock

■ Bulk Data Send

This function causes the contents of the registration and song memories to be

transmitted via the MIDI OUT connector. This data can be saved to memory or disk

via a MIDI sequence recorder or MIDI data recorder, and then reloaded when required.

The bulk data can also be sent directly to a second PSR-330.

To send the bulk data select the “BlkSnd?” function, then press the [+] (YES)

button. “Sure?” will appear on the display. Press [+] (YES) again to begin transmis-

sion of the bulk data. “BkSnd:Rg” (registration data) and then “BkSnd:Sg” (song data)

will appear on the display during transmission. “End” will appear on the display

briefly when the transmission has finished.

• A bulk dump trans-

mission can be

stopped at any time

by pressing the [–]

(NO) button.

• No other operations

can be performed dur-

ing bulk dump trans-

mission.

YES

BlkSnd?

Sure?

• Clock is “off” be de-

fault when the power

is initially turnd on.

• When Clock is turned

“on”, AUTO ACCOM-

PANIMENT playback

cannot be started or

stopped via the panel

[START/STOP] but-

ton, or started via the

synchro start function.

Also, the MULTI PAD

playback cannot be

initiated by pressing

the MULT PADs.

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 89 90

Kommentare zu diesen Handbüchern

Keine Kommentare

Yamaha PSR330 Bedienungshandbuch Seite 72

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Musikinstrumente Yamaha PSR330