Yamaha RX-A3060 Bedienungshandbuch Seite 29

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 199
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 28
En 29
Connection diagram
Refer to the following diagram and connect the speakers to the unit.
Y
When using only one surround back speaker, connect it to the SINGLE jack (L side).
Connecting speaker cables
Speaker cables have two wires. One is for connecting the negative (-) terminal of the unit and
the speaker, and the other is for the positive (+) terminal. If the wires are colored to prevent
confusion, connect the black wire to the negative and the other wire to the positive terminal.
1
Remove approximately 10 mm (3/8”) of insulation from the ends of the speaker cable, and
twist the bare wires of the cable firmly together.
2
Loosen the speaker terminal.
3
Insert the bare wires of the cable into the gap on the side (upper right or bottom left) of the terminal.
4
Tighten the terminal.
Using a banana plug
(U.S.A., Canada, Australia, Brazil and General models only)
1
Tighten the speaker terminal.
2
Insert a banana plug into the end of the terminal.
Connecting the subwoofer (with built-in amplifier)
Use an audio pin cable to connect the subwoofer.
1
2
ZONE OUT/PRE OUT
ZONE 2/
F. PRESENCE
ZONE 3/
R. PRESENCE
SPEAKERS
CENTER FRONT
SURROUND BACK
SURROUND
R.PRESENCE
R L R R RL L L
F. PRESENCE
ZONE 2/ZONE 3/BI-AMPZONE 2/ZONE 3/F.PRESENCE
EXTRA SP1
R
L
SINGLE
PRE OUT
SUBWOOFER
CENTER
FRONT
SURROUND SUR. BACK
(SINGLE)
(FRONT)
(REAR)
EXTRA SP2
12
3
45
99
T
6 7
Y
ER
The unit
(rear)
FRONT
-
+
11
2
2
4
4
33
+ (red)
– (black)
FRONT
+
11
22
Banana plug
(
SINGLE
)
PRE OUT
CENTER
SUR. BACKSURRUND
1
2
SURROUND BACK
L
(
REAR
)
SUBWOOFER
(
FRONT
)
Audio pin cable
Seitenansicht 28
1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 198 199

Kommentare zu diesen Handbüchern

Keine Kommentare