Yamaha P-100 Bedienungshandbuch PDF herunterladen (Seite 59)

ERROR MESSAGES

Whenever a problem occurs, the P-100 will display an error message to alert you to the nature of the trouble.

The meanings of the error messages are described below, together with the action you should take in response to each.

(The error messages themselves will be cleared from the display automatically as soon as you operate one of the

controls on the P-100’s upper panel.)

Backup battery low

The charge of the internal backup battery is running low. All of

your P-100’s setup data will be lost if the battery charge runs down

completely. Save any settings you may want to keep using the bulk

dump procedure, if possible, then contact your Yamaha dealer or a

Yamaha service center to have the battery replaced.

MIDI buffer full

The P-100 has received a greater volume of MIDI data than it can

process at one time. Take steps to reduce the amount of data the

P-100 is receiving.

MIDI data error

The P-100 had trouble receiving MIDI data. Check your cable

connections and try the operation again.

MIDI checksum error

The P-100 had trouble receiving a MIDI bulk dump. Check your

cable connections and try the operation again.

Bulk protected

The P-100 could not receive an incoming bulk dump because the

bulk protect function has not been turned off. Turn the bulk protect

off using the procedure described on page 36, then try the bulk

dump operation again.

Device number mismatch

The P-100 could not receive an incoming bulk dump because the

current receive channel (Rch) setting does not match the device

number recorded in the bulk data. The bulk data device number is

set equal to the P-100’s transmit channel (Tch) setting at the time

the data is dumped. Set the receive channel to this value using the

procedure described on page 33, then try the bulk dump operation

again.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 68 69

Keine Kommentare

Yamaha P-100 Bedienungshandbuch Seite 59